The OV303A ADSL Modem is a low-cost, optimized ADSL Ethernet bridge that is pre configured for bridge mode in compliance with RFC1483/2634. It is able to detect VPI/VCI configuration automatically, supporting up to 31 popular VPI/VCI settings. As a Plug and Play end user equipment, it is the best solution for most of the Telcos and ISPs to eliminate the tech support.

TECHNICAL SPECIFICATIONS

• T1.413 issue 2, G.lite and G.dmt Annex A, B ADSL standards
• Inter-op with all major DSLAMs based on Alcatel., ADI., Globespan., and TI. chipsets
• 1 VC with UBR ATM category (VCI, VPI pre-configured and Auto-configuration)
• Up to 8Mbps downstream data rate/ 1Mbps upstream data rate
• The most effective distance: 5.4 Km
• 10 Base-T half-duplex Ethernet interface for Eagle™ Bridge Device.
• 10/100 Base-T half-duplex Ethernet interface for Eagle II™ Bridge Device.
• RFC2684 (1483) bridged mode (VCMux and LLC) encapsulation
• Compact size
• Three connectors:
• Power
• Ethernet
• ADSL
• Only four LED indicators:
• Power (indicates power is ON/OFF)
• LAN (indicates Ethernet link is established)
• ADSL (indicates CO link is established)
• DATA (data transfering)
• No NT configuration is required as part of installation (The modem is fully factory-preconfigured to the operator.)
• Remote check of ATM Operational status (VP/VCC loopback and continuity check)
• Software upgrade from LAN
• Performance information is available for LAN hosts with web interface.
• Optional:
• Bridge Lock for enhanced security
• “Dying Gasp” support